The system includes mounting hardware, 2 liner encoders, 2 axis display and a manual.
This Mitutoyo DRO is one of the best on the market today. Use it with confidence. Mitutoyo makes a very cost effective DRO for us with manual mills. This system comes complete all everything you need to set-up your mill to use a DRO. Buy it now and install it next week.
-
Model KA 2 axis display
-
bolt hole calculation
-
preset for each axis
-
reset for each axis
-
1/2 divide for finding centerline
-
inch / metric conversion
-
50 position memory for each axis
-
radius / diameter switchable
-
memory compensation value
-
selecting co-ordinates 1 to 10
-
zero approach machining
-
pitch approach machining
-
ABS/INC= ten tool co-0rdinates (1absolute and 9 incremental )
-
AT715 liner scale
-
detection method: electromagnetic induction system
-
interface: Mitutoyo Original interface ( connectible only to KA counter)
-
effective length: 4" to 72" 100mm to 1800 mm
-
accuracy (20 degrees C ) 7+13XLO/1000 um (LO:effective length)
-
response speed 50 M/min
-
Dust and water Proof IP-55
-
110 volt
